Electia SDA-9 Instrucciones de operaciones descargar pdf (Pagina 9)

GUIDE TO INSTALLATION AND OPERATION

SDA-1401 | 5

3 Operation

3.1 Control options

The SDA-1401 can be controlled in two different ways:

• The local control panel and its push-buttons can be used to move through a menu of parameters and to

adjust parameter values (see section 3.3)

• Miranda’s iControl system can be used to access the card’s operating parameters from a remote

computer, using a convenient graphical user interface (GUI). (see section 3.4)

3.2 Card-Edge Status LED

The status monitor LED is located on the front card-edge of the SDA-1401, and is visible through the front

access door of the DENSITÉ frame. This multi-color LED indicates the status of the SDA-1401 by color, and

by flashing/steady illumination.

The chart shows how the various error conditions that can be flagged on the SDA-1401 affect the LED status.

• If a cell is gray, the error condition cannot cause the LED to assume that status

• If more than one LED status is possible for a particular error condition, the status is configurable.

See Section 3.4.5 for details.

• The factory default status is shown by a 

The LED will always show the most severe detected error status that it is configured to display, and in the

chart error severity increases from left to right, with green representing no error/disabled, and flashing red the

most severe error.

LED Status

Error Condition

Green Yellow Red

Flashing

Red

No errors



No signal



No lock (see note*)



No rear



* Note: in this case, ASI/SDI is not detected, but a DVB-SSI signal may be present

If the LED is Flashing Yellow, it means that the card is selected for local control using the Densité frame’s

control panel. See Section 3.3 for details.

3.3 Local control using the Densité frame control panel

3.3.1 Overview

Push the SELECT button on the SDA-1401 card edge (see Section 1.4) to assign the local control panel to

operate the SDA-1401. Use the control panel buttons to navigate through the menu, as described below.

All of the cards installed in a Densité frame are connected to the frame’s controller card, which handles all

interaction between the cards and the outside world. There are no operating controls located on the cards

themselves. The controller supports remote operation via its Ethernet ports, and local operation using its

integrated control panel.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comentarios a estos manuales

Sin comentarios

Electia SDA-9 Instrucciones de operaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Detectores de humo Electia SDA-9