Electia SDA-9 Instrucciones de operaciones descargar pdf (Pagina 12)

GUIDE TO INSTALLATION AND OPERATION

8 | SDA-1401

• If there are multiple errors, the error messages cycle so all can be seen

• The icon whose status or error message is shown is highlighted with a mauve background

In all cases, mousing over an icon will cause a more detailed description of its current status to appear in

the message area. Error message cycling will resume when the cursor is no longer over an icon.

The main section of the panel contains four tabs which give access to the various operating and status

monitoring features of the SDA-1401.

• Click on a tab to access its contents.

Each of the four tabs is described individually – see sections 3.4.3 to 3.4.6.

3.4.2

The Factory button

Click the Load Factory button at the bottom of the window to reset all parameters on this SDA-1401 card

to factory-defined default values.

3.4.3 The Status tab

The SDA-1401 can process the following signal formats:

• SMPTE 259M-C (270Mbps)

• DVB-ASI

• SMPTE-310M/DVB-SSI

This panel shows the status of the input signal and interface.

Signal Status: Signal OK, or an error message

 When reclocker is ON, Signal OK

indicates a 270 Mbps signal is present

 When reclocker is Bypassed, Signal OK

indicates a signal in the range 20 to 270

Mbps is present

Data Rate: The data rate detected at the input.

 Only 270 Mbps with reclocker ON is

specifically detected. In all other cases

this window will show N/A.

Rear type: Shows the type of rear panel installed in the

Densité frame for this SDA-1401.

Figure 3.4 Status panel





1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Electia SDA-9 Instrucciones de operaciones Pagina 12