Electia SDA-9 Guía de usuario descargar pdf (Pagina 20)

821667: VAMP2 Series User Guide

VAMP2 Series User Guide

Rear Panel Connectors

To monitor video from these inputs, set the following:

• The Video Source select button to SDI,

• The SDI Input select button to SDI input either (In 1 or

In 2

), and

• The

SDI Group select button to the SDI Group of choice (1,

2, 3, or 4).

To monitor audio (only) from these inputs, set the following:

• The Audio Source select button to SDI,

• The SDI Input select button input either (In 1 or In 2), and

• The SDI Group select button to the SDI Group of choice

(1, 2, 3, or 4).

Even if SDI is not selected for monitoring through the unit, you can

still select the SDI input (In 1 or In 2) and use the re-clocked SDI

Output

connector and CVBS Converted Video Output (from an

SDI input) Connector regardless of other settings. This feature

enables processing of the SDI signal independent of the unit’s other

monitoring functions.

• SDI Out (BNC): The output BNC connector outputs a re-clocked

HD/SD-SDI signal derived from the selected HD/SD-SDI input.

This output functions regardless of other selection settings enabling

output of the re-clocked HD/SD-SDI signal independent of the

unit’s other monitoring functions (as long as a valid HD/SD-SDI

signal is present at the input).

• (Optional) Unbalanced AES Out from SDI (HD-15): Unbalanced

AES signals de-embedded from the selected SDI input are output

from this HD-15 connector. See Figure 1–3 on page 19 for the

pin-out for this connector.

Note:

You can request the optional Unbalanced AES Out

from SDI HD-15 connector instead of the Balanced

AES Out from SDI DB-25

connector at the time you

place your order.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

Electia SDA-9 Guía de usuario Pagina 20